Use and Care Manual

Battery pack not engaged
Check battery pack is
fully engaged onto
properly
connectors
Charger plugged in
Unplug charger
Button on battery pack
Reset circuit-breaker
popped out
button
Disconnected loom or
Check all plugs &
plugs
looms
Control system fault
Contact dealer
Motor runs
Electrical malfunction
Contact dealer
irregularly
Control system fault
Contact dealer
and/or noisily
DO NOT ATTEMPT TO OPEN ANY PARTS OF THE SCOOTER
CONTROL SYSTEM, BATTERY PACK, LOOMS, PLUGS OR BATTERY
CHARGER.
THE CONTROL SYSTEM IS SAFETY CRITICAL AND THERE ARE NO
USER SERVICEABLE PARTS
Your scooter is fitted with a self diagnostic controller that will give a
sequence of audible beeps when an error is detected to help you, or
the authorized service agent, determine the drive electronics fault.
Should you switch on the scooter and hear the beeps note the number
of beeps, separated by a short delay between each sequence, and refer to
the table below.
NUMBER
REPRES
POSSIBLE
OF
SOLUTION
ENT
CAUSE
BEEPS
1
Battery
Power not
The battery needs
power low
enough
harging
Low
Power not
The battery needs
2
battery
enough
harging
voltage
High
Too higher
Decrease speed
voltage, while
while climbing
3
battery
overloading or
Check battery
voltage
climbing
connection
44