Product Manual

11
• Every 12 months or 250 hours of use:
1. F
ollow the above regularly scheduled maintenance guidelines for every 3 months or 25 hours of
use on page 9.
2. Follow the above regularly scheduled maintenance guidelines for every 4 months or 50 hours of
use on page 10.
3. Remove and service the hammer and anvil according to guidelines in the section of this manual
titled Servicing of Hammer and Anvil on page 12.
4. Replace all O-rings and housing seals. A rebuild kit including all the Viton O-rings, seals, grease,
and Loctite is available from Titan Post Drivers.
The amount and type of grease used in your Titan Post Driver is critical for the performance and service life
of your post driver. Not enough grease will cause failure, and too much grease will overburden the piston and
affect the hammering power of the machine. Use only Titan-approved EP 0 grease, which is available from
Titan Post Drivers.
ALWAYS reassemble your driver fasteners using LOCTITE BLUE 243. Remember to clean the fastener and
the holes with a parts cleaner to remove all grease residue, or the Loctite will not be effective.
If you are unsure of anything in this manual, please contact Titan Post Drivers directly at [phone].
If you are experiencing performance issues with your Titan Gas-Powered Post Driver, please refer to the
section of this manual titled Troubleshooting on page 16 for possible solutions, or contact Titan Post Drivers
for assistance.