Product Manual

15
7. I
nstall the metal damper washer back over the anvil.
8. Install the bottom guide section back into the main housing. Be sure to install the new bottom
housing O-ring.
9. Insert the anti-vibration springs back into the handlebars and reinstall them into the upper a
nd
l
ower handle cups. When parts are inserted correctly, there will be resistance from the springs to
seat the lower driver body. This is normal.
10. Reinstall the bottom housing bolts with new Loctite. You must clean the bolt and the area of the
bol
t hole with parts cleaner to remove any grease residue. The Loctite will not be effective if
grease is present. Torque these bolts to 132 inch-pounds.
11. Add approximately 4 tablespoons of new EP 0 grease to the crank area and reinstall the crank
cover bolts with new Loctite. You must clean the bolt and the area of the bolt hole with parts
cleaner to remove any grease residue. The Loctite will not be effective if grease is present.
All screws should be correctly tightened in an alternate pattern as machine damage will occur from
loose or lost bolts due to improper installation.
Please contact Titan Post Drivers directly at [phone] if you need parts or have any servicing
questions.