Use and Care Guide

TYPICAL PROPERTIES
• Viscosity: 3,600,000 cps
• Working Time: 10 minutes, depending on temperature and humidity
• Color: White
• Flash Point: >212° F
• Odor: Low
• Application Temperature: 0° F - 120° F (60° F - 90° F for
best results). Above 90° F, use additional support for 24 hours.
• Calculated VOC: < 4 g/L (0.26% w/v)
• Storage Life: 1 year
PREP
• Surfaces must be clean, dry and free from dust, grease and
other loose material.
DIRECTIONS
1. Surfaces must be flat, completely dry and free of any material that
may prevent adhesion.
2. Cut across tube’s nozzle base (see image A) and screw on the
included v-notch applicator tip (see image B), which must be used
to ensure correct depth of adhesive is extruded. Place in premium
cartridge gun, as material is highly viscous.
3. Hold cartridge gun at a 90° angle relative to substrate surface.
The notch of the applicator should form a ridge on top of the
adhesive bead when applied correctly (see image C).
4. Apply adhesive coverage based on substrate weight to one of the
surfaces in a continuous, horizontal bead, staying 1/2 inch from the
outside edge (see image D). Correct bead placement is achieved by
dividing total bead coverage into equal lengths of a minimum of
three beads at least 1.5 inches separating each bead centered on
the substrate. For questions about bead placement, contact Technical
Service at 1.800.347.4583.
5. Press surfaces firmly together with a slight twisting motion and
firmly hold for 5 seconds. NOTE: On extremely heavy items,
temporary support may be necessary during the curing process.
Certain large applications may require additional permanent bracing.
Mechanical fixings should always be used in overhead applications.
Use only in well-ventilated areas.
LIMITATIONS
• Not recommended for applications on PE, PP, PC, PMMA, PTFE,
neoprene and bituminous substrates. Not recommended for
continuous underwater applications or expansion joints. Not suitable
in combination with chlorides (pools). Yellowing may occur in the
dark. Not suitable as joint sealant. Not paintable with alkyd resin
paints. Porous surfaces may require a primer. Adhesion tests prior
to application are recommended. It is the user’s responsibility to
determine suitability. Store between 41°̊F and 77°̊F in cool,
dry conditions.
COVERAGE
• 9.5 fl. oz. cartridge equates to 210 linear inches and the substrate
coverage is 2.5 inches of standard sized bead per pound of substrate.
CLEAN UP
• Tools and adhesive may be cleaned with mineral spirits or acetone
when uncured. Follow solvent vendor’s precautions. Once cured,
adhesive must be scraped from surface.
STORAGE
• Store in a cool, dry place out of direct sunlight. Will not freeze
or be damaged by low temperatures. Avoid storage temperatures
above 120° F.
A B C
D