User's Manual

2-15
Chapter 2: UNIT AND SOFTWARE INSTALLATIONS
5.4.3. Installation folder configuration
The installed software program is stored by default in C:\Program Files\TOA\NX-100. The installation folder is
configured as follows. (However, the unit setting file is only created after having been set by the setup
program, and the unit operation log is created after the NX-100/100S unit's first actual operation.)
Installation Folder
Config (folder to store unit setting files) [IP address].cfg (unit setting file)
Log (folder to store logs)
nx100_control.jar (Operation Program)
nx100_util.jar (Setup Program - Installation Setting)
packet_audio.jar
data (data folder)
System.nxc (setup program system file)
panel.nxc (operation program system file)
[IP address].log (unit operation log file)
Data in the data folder are commonly used by both the Setup Program and the Operation Program. The Setup
Program and the Operation Program always operate based on the unit setting files in the data folder.
Manually opening or saving these files cannot be performed.
Do not change the configuration or name of the file or folder in the installation folder.
When creating other systems or saving backup copies, copy the data folder into other location and save it. (To
reuse, replace the data folder with the one in use.)
5.5. Uninstalling Each Software
Select [Control Panel] → [Add/Remove Programs] to delete.