User's Manual

3-3
Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)
2. SETUP SOFTWARE CONFIGURATION AND SETTING ITEMS
The Installation Setting Program permits settings of all items including unit scanning and network setting. First
set all items using this software at the time of system installation. The following two tools are made available:
[Unit Scanning Tool]
Performs unit scanning and network settings. Using this tool, first scan the NX-100 and NX-100S units
connected to the LAN for the system initial setting.
[System Setting Tool]
Performs settings of unit broadcast, contact, serial bridge, etc. It is possible to create the system setting file
beforehand by entering a unit setting before installation.
Setting Item
Unit Scanning Tool Unit scanning (See p. 3-10)
IP address (See p. 3-11)
Subnet mask (See p. 3-12)
Default gateway (See p. 3-12)
System Setup Tool Network (See p. 3-16)
Broadcast spec (See p. 3-18)
Broadcast pattern (See p. 3-20)
Contact (See p. 3-23)
Serial bridge (See p. 3-27)
System (See p. 3-29)
NX-100 only
Setting items table