User's Manual

5-9
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
Step 3. Click on the Button layout tab, then perform settings for each item shown on the screen.
In the initial startup mode, the following screen is displayed.
(1)
(2)
(3)
(1) Enable start button
When the box is unchecked, the Start button on the operation screen is disabled and hidden. In this case,
pressing the Selection or Group button automatically starts connection to the NX-100 or NX-100S
programmed for that button.
[Number of buttons]
Set the number of buttons on the operation screen.
There is no limit to the number of buttons that can be set.
(2) Single selection button: horizontal, vertical
Set the number of Single Selection buttons.
The number is preset to 5 horizontal by 10 vertical buttons (total 50 buttons).
(3) Group button: horizontal, vertical
Set the number of Group buttons.
The number is preset to 1 horizontal by 10 vertical buttons (total 10 buttons).
Step 4. Press the OK button after completing all editing tasks.
The setting contents are saved to the data folder located in the installation folder (default path:
C:\Program Files\TOA\NX-100) of the software program, and the Button Setting screen is closed.