Blender User Manual

CARE AND CLEANING

1. Unplug from wall outlet.

2. Remove Blender Jar from Blender Base.

3. Empty the Blender Jar completely. Rinse the inside with water, then remove

the black plastic Jar Base and Cutting Blade Assembly by turning the Jar

Base counterclockwise.

4. Remove the Cutting Blades and Gasket. NOTE: Use extreme caution when

handling the Cutting Blade Assembly, the blades are very sharp.

5. Wash the Blender Jar, Lid, Filler Cap, Jar Base, Gasket and Cutting Blades in

warm soapy water. Rinse, air dry thoroughly and reassemble.

6. To reassemble, place the Gasket over the top of the Cutting Blades

(BECAREFUL AS THE BLADES ARE SHARP) and slide the Gasket to the bottom

edge of the Cutting Blade assembly. Fit the Cutting Blades through the hole

in the Blender Jar. Place the Jar Base over the bottom of the Jar and turn

clockwise.

7. Wipe the Blender Base with a damp cloth. If necessary, you can use a little

mild detergent. DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID.

DO NOT use harsh detergents or abrasive cleaners on any part of the

appliance.

Booklet_TBL634_EN.qxd:Salton Booklet 3/23/11 2:47 PM Page 5