Instructions / Assembly

TQ2 TQ2
4. Reversible Levers
5. Install Outside Lever
Insert spindle through latch.
Press flush against door.
6. Install Inside Lever
Install inside lever and
tighten screws until lock is firm.
7. Install Strike
a. Close door to make horizontal
centre line of strike.
A.
B.
C.
c. Install strike and tighten screws.
b. Measure one half of door thickness
from door stop and mark vertical
centre line of strike.
Drill 1"(25.4mm) hole 1/2"(13mm)
deep at intersection of horizontal
and vertical line of strike.
Match screw holes on strike with
centre lines on jamb.
Mark outline and chisel 1/16"
(1.6mm)deep for strike.
Handle can be only
installed when the timing
of "emergency release"
is set in the position
shown below.
RIGHT
HAND DOOR
LEFT
HAND DOOR
54mm (2-1/8")
FOR BACKSET ( )70mm 2-3/4"
FOR BACKSET ( )60mm 2-3/8"
Rev. 13/10/2011
45
40
35
1-3/4" 1-3/8"1-9/16"
2-1/4" (57mm)
5.5mm 7/32"
hole for metal
door only
( ) x 2
Make 1"(25.4mm)hole at center of door edge.
Fold on dotted line and fit on door edge
TEMPLATE
Fold on dotted line and fit on door edge
a. Please check the levers are unlocked(Entrance sets only).
Depressing lever catch with hand tool to release outside lever and pulling lever off.
Taking apart off the and cylinder from outside lever.
b. Reversing the levers from outside to inside/inside to out side, putting the cylinder
on the outside lever (Entrance sets only).
Please do the same procedures for inside lever.
c. Pushing handles in until catch clicks. Make sure levers are retained by lever.