User Manual

EN - 24
The plug should be comfortably accessible aer the
appliance has been installed.
• Aer installing the appliance to a suitable place, run it
unloaded for the rst me.
POSITIONING THE APPLIANCE
• When determining a place to posion the dishwasher, make
sure you choose a place where you can easily load and
unload your dishes.
• Place the appliance on a solid and at surface.
• Do not place the appliance in any locaon where there is the
probability for the room temperature to fall below 0°C.
• Posion the appliance close to a water tap or drain and
socket. Take into consideraon that the connecons will not
be altered when they are made.
• Do not grip the appliance by its door or control panel in
order to move it.
Make sure that the water inlet and outlet hoses do not get
stuck while posioning the appliance.
CONNECTING TO THE WATER TAP AND DRAINAGE
• Make sure that the indoor plumbing is suitable for installing
a dishwasher. Also, we recommend that you t a lter at the
beginning of the water supply in your house to avoid any
damage to your appliance because of any contaminaon
(sand, clay, rust, etc.) that might occasionally carried in
through the mains water supply.
Always use the new water inlet hose supplied with your
appliance. If you are using the new water inlet hose, run
water through it for a while before making the connecon.
Connect the water inlet hose directly to to the water inlet
tap. The pressure supplied by the tap should be at a
minimum of 0,03 Mpa and at a maximum of 1 Mpa. If the
water pressure is above 1 Mpa, a pressure-relief valve