User Manual
USING THE APPLIANCE FOR THE FIRST TIME
Before using the appliance for the rst me, you should proceed as follows: carefully unpack the appliance and remove all
packaging material, also from the inside, and any promoonal sckers.
Keep the packaging (plasc bags, polystyrene and cardboard) out of the reach of children.
Aer unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Place the appliance on a sturdy, at surface. Prior to using the machine for the rst me please check whether the electricity
and supply water specicaons match the values indicated by the installaon instrucons for the appliance.
Remove all packaging materials inside the machine.
Fill the salt reservoir and ll up with water unl it almost overows. Set the water hardness seng.
Fill the rinse aid reservoir.
FILLING THE SALT RESERVOIR
For a good washing result, the dishwasher needs so, i.e. less calcareous water. Otherwise, white lime residues will remain
on the dishes and the interior of the dishwasher. This has a negave eect on your applinace’s washing, drying and shining
performance. For this purpose, dishwasher salt is used.
• Remove the basket and unscrew the cap of the
salt reservoir (1).
• Fill with salt ll the overow level, about 1.0 kg
(2).
• Fill the reservoir before rst use with water. It
is normal for a lile water to ow out of the
opening when doing this.
• Screw the cap back on rmly.
ATTENTION!
• Remove any spilled salt and run a full program to prevent corrosion to the boom.
• Rell the salt reservoir when the indicator light of the salt reservoir lights up.
SETTING THE SALT CONSUMPTION
To nd out the water hardness level in your area, contact your local water company. Adjust the salt consumpon according to
the table on the next page.
Hardness level is adjusted to level 4 as a factory seng.
• Close the door and switch on the machine.
• Press and hold the Program button P for 5 seconds to enter the mode for setting the salt consumption. This must be set
within 60 seconds after turning the machine on.
• Set the level by pressing Program button P repeatedly. Use the table of water hardness level settings.
• After adjusting the level of water hardness, press the On/Off button to confirm and store the setting. If the setting is not
confirmed, it is stored automatically after 5 seconds.
1)
2)
3)
H1
0-5 0-0.9 ● indicator light RAPID30 on none
H2
6-11 1.0-2.0 ● indicator light DELICATE on 10
H3
12-17 2.1-3.0
● indicator light DELICATE on
● indicator light RAPID30 on
5
H4 *
18-22 3.1-4.0 ● indicator light ECO on 3
H5
23-34 4.1-6.1
● indicator light ECO on
● indicator light FAST30 on
2
H6
35-45 6.2-8.0
● indicator light ECO on
● indicator light DELICATE on
1
1
Open
2
EN - 30