User Manual
1) German degree of measurement for the water hardness
2) millimol, internaonal unit for water hardness
3) Each program cycle with a regeneraon process consumes addional 2.0 litres of water. The energy consumpon increases
by 0.02 kWh and the program extents by 4 minutes.
* factory seng
FILLING WITH RINSE AID AND SETTING THE CONSUMPTION
Rinse aid is used to prevent traces of water droplets being le on the clean dishes. It also increases the drying performance,
since the water drains o more easily. Only use rinse aid which is designed for use in dishwashers.
• The rinse aid reservoir is located on the inside of the door, alongside the detergent
reservoir.
• Unscrew the cap of the rinse aid reservoir (1).
• Fill the rinse aid reservoir until the rinse aid level indicator turn dark (2).
full
3/4 full
1/2 full
1/4 full, should refill to eliminate spotting
empty
• Replace the cap and make sure it lines up with the indication marks (3).
• The rinse aid level can be adjusted between the setting 1 and 6. The factory setting for rinse aid is level 4.
Unscrew the cap and use a large screwdriver to set the correct level (3). You need to increase the level
of rinse aid when water stains form on your dishes after a wash program. Decrease it when strips or blue
stains form on the dishes. Keep adjusting the level until the dishes are streak-free when you take them
out of the dishwasher.
• Refill the rinse aid reservoir when the rinse aid indicator lights up.
• Do not overfill the rinse aid reservoir. The reservoir will overflow.
• Spilled rinse aid must be cleaned up. Otherwise they may lead to leakage as a result of extreme foaming.
1 32
EN - 31