User Manual
EN - 37
CLEANING THE DRAIN PUMP
Large food residues or foreign objects which were not captured by the lters may block the waste water pump. The rinsing
water will then be above the lter.
When cleaning the waste water pump, ensure that you do not injure yourself on pieces of broken
glass or pointed implements.
• First always disconnect the appliance from the power supply.
• Take out the basket.
• Remove the lters.
• Scoop out the water, use a sponge or cloth if required.
• Check the area and remove any foreign objects.
• Install the lters.
PLACING THE DISHWASHER
Posion the appliance in the desired locaon. Make sure the locaon is solid and at. The dishwasher is equipped with water
supply and drain hoses that can be posioned either to the right or the le sides to facilitate proper installaon.
ELECTRICAL CONNECTION
Ensure the voltage and frequency of the power corresponds to those on the rang label. Only insert the plug into an electrical
socket which is earthed properly. Use the required fuse 16 amp.
COLD WATER CONNECTION
Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is fastened
ghtly in place.
If the water pipes are new or have not been used for an extended period of me, let the water run to
make sure that the water is clear. This precauon is needed to avoid the risk of the water inlet to be
blocked and damage the appliance.
Aenon: the dishwasher can not be connected to a warm water supply.
DRAIN HOSE CONNECTION
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into the sink, making sure to avoid
bending or crimping it. The top of the hose must be less than 600 mm.
Counter
please hang up the drain hose either way A or B
front
drain pipe
Note: the top of the
hose must be less
than 600 mm.
Ø 40 mm
A
B
MAX 600 mm