Instructions / Assembly

3
Using the Drill Bit, drill two (2) more holes (3a & 3b) through the End Rail and into the Side Rail.
Secure End Rail to Side Rail using two (2) Deck Screws (3c). Use the Driver Bit to fully tighten the
Deck Screws (3d). Repeat this procedure for three (3) ramaining corners.
4
Measure approximately 24” to center the Center Rail (4a). Using a Pencil and a Sliding Square,
extend a vertical line onto the side of the End Rail (4b). Repeat this procedure for other end of the
Center Rail.
Center Rail
End Rail
4a 4b
3d
3c3a 3b
2x