Installation Guide

9
Install Post Bumpers (optional), and refer to available option sheet for bumper installation instructions
(9a). Install all Safety Caps onto each post (9b).
Note: If your dock settles or if water level fluctuates, the leveling operation should be done without
removing L pins. When mooring your crafts at docks, replace 1/2-13x2-1/4” bolts with 1/2-13x3”
eye bolts where needed (do not use L pin holes). Mark each dock section to make next spring’s
installation easy.
Safety
Cap
Post
9b
Optional
Post Bumper
9a