Installation Guide

Tommy Docks Bracket Installation
A-Bracket (outside corner)
1. Position A-Bracket (refer to dock layout)
making sure that dock’s frame is seated
completely in the saddle of the A-Bracket.
2. Drill two (2) 1/2” diameter holes.
3. Install two (2) 1/2” x 2-1/4” bolts, washer and
nuts. The nuts are positioned on the inside of the
dock’s frame.
A-Bracket (outside corner)
B-Bracket (Stright Side)
C-Bracket (inside corner)
D-Bracket (inside corner)
A-Bracket (outside corner)
B-Bracket (Stright Side)
C-Bracket (inside corner)
D-Bracket (inside corner)
B-Bracket (straight side)
1. Position B-Bracket (refer to dock layout)
making sure that dock’s frame is seated
completely in the saddle of the B-Bracket.
2. Drill two (2) 1/2” diameter holes.
Note: Do not attempt to drill pin assembly hole
in next dock section until your dock is completely
installed on water and leveled.
3. Install one (1) 1/2”-13 x 2-1/4” bolt, washer
and nut. The nut is positioned on the inside of
the dock’s frame.
C-Bracket (inside corner)
For connecting two dock sections
1. Position C-Bracket (refer to dock layout) making
sure that dock’s frame is seated completely in
the saddle of the C-Bracket. Header frame must
not protrude past the angle plate or the next
dock section will hit.
2. Drill one (1) 1/2” diameter hole.
Note: Do not attempt to drill pin assembly hole
in next dock section until your dock is completely
installed on water and leveled.
3. Install one (1) 1/2”-13 x 2-1/4” bolt, washer
and nut. The nut is positioned on the inside of
the dock’s frame.
D-Bracket (inside corner)
For connecting three dock sections
1. Position D-Bracket (refer to dock layout)
making sure that dock’s frame is seated
completely in the saddle of the D-Bracket.
Header frame must not protrude past the angle
plate or the next dock section will hit.
2. Drill one (1) 1/2” diameter hole.
Note: Do not attempt to drill pin assembly hole
in next dock section until your dock is completely
installed on water and leveled.
3. Install one (1) 1/2”-13 x 2-1/4” bolt, washer
and nut. The nut is positioned on the inside of
the dock’s frame.
Inside
Dock
Outside
Dock
Dock Frame
Dock
Frame
1/2” Flat
Washer
1/2” NC Hex Head
Cap Screw x 2-1/2”
1/2” NC
Hex Nut
1/2” Flat
Washer
1/2” NC
Hex Nut
1/2” NC Hex Head
Cap Screw x 2-1/2”
1/2” Dia. Pin
Dock
Frame
Dock Frame
Dock
Frame
Inside
Dock
1/2” Flat Washer
1/2” NC Hex Nut
1/2” NC Hex Head
Cap Screw x 2-1/2”
1/2” Dia. Pin
1/2” Dia. Pin
Outside
Dock
Dock Frame
Dock
Frame
Dock
Frame
Inside
Dock
Inside
Dock
1/2” Flat Washer
1/2” NC Hex Nut
1/2” NC Hex Head
Cap Screw x 2-1/2”
Outside
Dock
Dock
Frame
Dock Frame
Dock Frame
Dock
Frame
Inside
Dock
Inside
Dock
Inside
Dock
Outside
Dock