User manual
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright
2015
by Conrad Electronic SE.
V1_1115_02-HK
b) Cutting a male thread
mm/inch
OFF ON ZERO
0 3
1 2 3 19 2 3 4 5 6 7 8
10 80 90 100
110
1
• Determine the correct external diameter of the blank. Align the blank with the nut that you wish to use.
• Choose the correct bolt die. Insert the bolt die into the die holder. Secure the bolt die using the screw on
the die holder.
• Insert the die holder into the tap wrench (ratchet).
2
mm/inch
OFF ON ZERO
0 3
1 2 3 19 2 3 4 5 6 7 8
10 80 90 100
110
• Set the direction of rotation for the handle to the right position.
• Apply a small amount of cutting oil to the blank.
• Turn the thread in a clockwise direction.
3
mm/inch
OFF ON ZERO
0 3
1 2 3 19 2 3 4 5 6 7 8
10 80 90 100
110
• Set the handle to the left position.
• Turn the bolt die anticlockwise to remove iron lings and remove the bolt die from the workpiece.
4
mm/inch
OFF ON ZERO
0 3
1 2 3 19 2 3 4 5 6 7 8
10 80 90 100
110
• Remove loose iron lings and screw the nut onto the nished thread.
• It may be necessary to apply a small amount of oil to the thread.
c) Storage
Apply a small amount of oil to the bolt die and screw tap for storage.
Store the product in a cool, dry place. Ensure that no condensation forms.