User manual

Note: It is recommended to use the variable speed feature

for a short time only. Do not continuously operate the tool at

different speeds. It may damage the switch.

d) Auxiliary Handle

An auxiliary handle (7) is packed with the drill for ease of operation and

to help prevent loss of control. The handle can be rotated 360°and it can

also be mounted on the opposite side for left hand use.

• SeegureE.

• Loosen the handle by turning the handle counterclockwise.

• Rotatethehandletothedesiredoperatingposition

• Securely tighten by turning the handle clockwise.

e) Depth gauge

• SeegureF.

• Change the position of the depth gauge (2), turn the grip of the handle

anti-clockwise until the depth gauge is loose enough to slide in the

hole.

• Set the depth, checking the depth with a steel ruler for most accurate

measurement and then turn the handle grip clockwise to tighten both

the depth gauge and the auxiliary handle in the required position.

f) Selecting the impact/drill mode

• SeegureG.

The impact/drill switch (1) should be set according to the type of action

required. The tool has two settings:

Drill mode

For drilling into wood and metal.

Use standard drill bits.

Impact mode

For drilling into stone and masonry.

Use masonry drill bits.

Fig. G

Fig. F

Fig. E