User manual
23
• Always switch off before you put the drill down.
• Ensure that the lighting is adequate.
• Keep the area free of tripping hazards.
• Only use accessory bits in good condition.
• Before drilling, check that there is sufcient clearance for the drill bit under the workpiece.
• Do not touch the bit after operation. It will be very hot.
• Keep your hands away from under the workpiece.
• Never use your hands to remove dust, chips or waste close by the bit.
• Rags, cloths, cord, string and the like should never be left around the work area.
• Support the work properly.
• If you are interrupted when operating the drill, complete the process and switch off before looking up.
• Periodically check that all nuts, bolts and other xings are properly tightened.
• When using the drill, use safety equipment including safety glasses or shield, hearing protection, and
protective clothing including safety gloves. Wear a dust mask if the drilling operation creates dust.
• Children and frail people must not use this tool. Children should be supervised at all times if they are in
the area in which the tool is being used. It is also imperative that you observe the accident prevention
regulations in force in your area.
• Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool’s construction and design:
- Damage to the lungs if an effective dust mask is not worn.
- Damage to hearing if effective hearing protection is not worn.
- Hand-arm vibration syndrome if its use is not adequately managed.