User manual

26
d) The On/Off switch
• See gure A.
• Switch the machine on by pressing the On/Off switch (1). When
releasing the On/Off switch (1), the machine will turn off.
• The rotation-speed can be continuously adjusted by pressing the On/
Off switch (1) deeper or less deep.
e) Lock-on button
• See gure A.
• Lock the On/Off switch (1) by pressing the On/Off switch (1) and then
pressing the lock-on button (2).
• Release the switch-lock by shortly pressing the On/Off switch (1) again
f) Function selection switch
In order to avoid damage to the machine, adjusting the
function selection switch (3) shall only be done when machine
is not running.
• See gure C and D.
• The correct position of the function selection switch (3) for each
function is shown in g. D. Always make sure the function switch clicks
in the desired position.
• Press the unlocking button on the function selection switch (3), and
rotate it to the desired function at the same time:
- A. Drilling (without hammer function): for drilling in several materials.
- B. Hammer Drilling (with hammer function): for drilling in masonry
such as brick, concrete and similar material.
- C. Chisel angle adjustment: for changing the angle of the chisel.
Insert the chisel, and adjust the angle by turning it to the correct
position. When set under right angle, turn the function selection
switch (3) to position D before using the tool.
- D. Chipping (chisel function): for chipping and small demolition jobs.
g) User tips
Always use the machine with the side handle rmly anchored in place
– you will not only work more comfort, you will also work with more
precision.
Caution: drills and chisels can get very hot.
• Drilling and hammer drilling (function A and B)
Fig.C
Fig.D
A. Drilling
B. Hammer drilling
C. Chisel angle adjustment
D. Chipping