Product Manual

RAISING THE JACK (continued)
CAUTION: NEVER WIRE, CLAMP OR OTHERWISE DISABLE THE LIFT CONTROL
VALVE TO FUCTION BY ANY MEANS OTHER THAN BY USING THE OPERATOR'S HAND.
USE THE HANDLE PROVIDED WITH THIS PRODUCT OR AN AUTHORIZED
REPLACEMENT HANDLE TO ENSURE PROPER RELEASE VALVE OPERATION. DO NOT
USE EXTENSIONS ON THE OPERATING HANDLE.
LOWERING THE JACK
1. Raise load high enough to allow clearance for the jack stands to be removed, then
carefully remove jack stands.
2. Remove support stands.
3. Grasp the handle firmly with both hands. Securely hold on to the jack handle so your
hands do not slip and ensure the release valve does not rapidly lower.
4. Carefully open the Release Valve by slowly turning the handle counter-clockwise. Do not
allow bystanders around the jack or under the load when lowering the jack.
5. After removing jack from under the load, keep jack in the lowered position to reduce
exposure to rust and contamination.
WARNING USE EXTREME CAUTION WHEN LOWERING THE JACK. THE JACK
HANDLE MAY TURN RAPIDLY. OPENING THE RELEASE VALVE TOO FAST CAN CAUSE
THE JACK TO LOWER RAPIDLY. FAILURE TO HEAD THESE WARNINGS COULD CAUSE
SERIOUS INJURY OR DEATH.