Product Manual

TO ADD JACK OIL:
1. Position the jack on level ground and lower the saddle.
2. Remove the oil plug.
3. Fill the oil case until oil level is just beneath the lower rim of the oil fill hole.
4. Replace oil plug.
5. Perform the Air Purge Procedure.
TO REPLACE JACK OIL:
1. Position the jack on level ground and lower the saddle.
2. Open release valve by turning handle counter-clockwise.
3. Remove the oil fill plug.
4. Turn the jack on its side to drain old oil from the oil fill hole.
5. Position the jack on level ground and keep saddle in the lowered position. Fill the oil case
until oil level is just beneath the lower rim. Keep dirt and other foreign materials clear
when pouring.
6. Replace oil plug.
7. Perform Air Purge Procedure.
ADDITIONAL WARNINGS:
 DO NOT USE MOTOR OIL IN THE JACK.
 ONLY USE ANTI-FOAMING JACK OIL.
 ALWAYS USE A GOOD GRADE HYDRAULIC JACK OIL.
 DO NOT USE HYDRAULIC BRAKE FLUID, ALCOHOL, GLYCERINE, DETERGENT,
MOTOR OIL OR DIRTY OIL.
 USE OF A NON-RECOMMENDED FLUID CANCAUSE DAMAGE TO A JACK.
 AVOID MIXING DIFFERENT TYPES OF FLUID AND NEVER USE BRAKE FLUID,
TURBINE OIL, TRANSMISSION FLUID, MOTOR OIL OR GLYCERIN. IMPROPER FLUID
CAN CAUSE PREMATURE FAILURE OF THE JACK AND THE POTENTIAL FOR SUDDEN
AND IMMEDIATE LOSS OF LOAD.
 DISPOSE OF HYDRAULIC FLUID IN ACCORDANCE WITH LOCAL REGULATIONS.
ADDITIONAL LUBRICATION:
1. Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed
and wipe with an oil cloth. NEVER USE SANDPAPER OR ABRASIVE MATERIAL ON THESE
SURFACES!
2. When not in use, store the jack with pump piston and ram fully retracted.