Reference Guide

Revision 1 02-24-2021 Toro Form No 3445-717 Rev A
Tool Inspection Process
Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete
procedures, refer to the Operator’s Manual):
Maintenance Service Interval Maintenance Procedure
Before each use or daily
• Check the engine-oil level and add oil as needed.
• Check the blade-brake-clutch operation.
• Ensure that the engine stops within 3 seconds after releasing the blade-control bar.
• Clean grass clippings and dirt from under the machine.
• Check the air filter and clean or replace it, if necessary.
• Check the cutting blades.
After the first 5 hours • Change the engine oil.
Every 50 hours • Clean the air filter; clean it more frequently in dusty operating conditions.
• Change the engine oil.
• Service the blade-drive system.
Every 200 hours • Replace the air filter; replace it more frequently in dusty operation conditions.
Before storage • Empty the fuel tank before annual storage.
Yearly
• Service the air filter; service it more frequently in dusty operating conditions.
• Change the engine oil.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
Important: Refer to the Engine Operator's Manual for additional maintenance procedures.
Tool Rental Center
Tool Turn Guide
TimeMaster® 30in Lawn Mower
Model No.
21199HD—400000000 and Up
Supplier Technical Support #:
800-888-9926 (US and Canada)
Supplier Website: www.Toro.com
PURPOSE
Follow the directions below to maintain this tool.
SAFETY
Refer to the product Operator’s Manual for complete safety information.