SDS for Oil
Precautionary statement(s) Response
Not Applicable
Precautionary statement(s) Storage
Not Applicable
Precautionary statement(s) Disposal
Not Applicable
SECTION 3 COMPOSITION / INFORMATION ON INGREDIENTS
Substances
See section below for composition of Mixtures
Mixtures
CAS No %[weight] Name
Not Available >60
SECTION 4 FIRST-AID MEASURES
Description of first aid measures
Eye Contact
If this product comes in contact with eyes:
Wash out immediately with water.
If irritation continues, seek medical attention.
Removal of contact lenses after an eye injury should only be undertaken by skilled personnel.
Skin Contact
If skin or hair contact occurs:
Flush skin and hair with running water (and soap if available).
Seek medical attention in event of irritation.
Inhalation
If fumes, aerosols or combustion products are inhaled remove from contaminated area.
Other measures are usually unnecessary.
Ingestion
If swallowed do NOT induce vomiting.
If vomiting occurs, lean patient forward or place on left side (head-down position, if possible) to maintain open airway and prevent aspiration.
Observe the patient carefully.
Never give liquid to a person showing signs of being sleepy or with reduced awareness; i.e. becoming unconscious.
Give water to rinse out mouth, then provide liquid slowly and as much as casualty can comfortably drink.
Seek medical advice.
Most important symptoms and effects, both acute and delayed
See Section 11
Indication of any immediate medical attention and special treatment needed
Treat symptomatically.
Heavy and persistent skin contamination over many years may lead to dysplastic changes. Pre-existing skin disorders may be aggravated by exposure to this product.
In general, emesis induction is unnecessary with high viscosity, low volatility products, i.e. most oils and greases.
High pressure accidental injection through the skin should be assessed for possible incision, irrigation and/or debridement.
NOTE: Injuries may not seem serious at first, but within a few hours tissue may become swollen, discoloured and extremely painful with extensive subcutaneous necrosis. Product may be forced
through considerable distances along tissue planes.
SECTION 5 FIRE-FIGHTING MEASURES
Extinguishing media
Foam.
Dry chemical powder.
BCF (where regulations permit).
Carbon dioxide.
Water spray or fog - Large fires only.
Special hazards arising from the substrate or mixture
Fire Incompatibility Avoid contamination with oxidising agents i.e. nitrates, oxidising acids, chlorine bleaches, pool chlorine etc. as ignition may result
Special protective equipment and precautions for fire-fighters
Fire Fighting
Alert Fire Brigade and tell them location and nature of hazard.
Wear full body protective clothing with breathing apparatus.
Prevent, by any means available, spillage from entering drains or water course.
Use water delivered as a fine spray to control fire and cool adjacent area.
Avoid spraying water onto liquid pools.
DO NOT approach containers suspected to be hot.
Fire/Explosion Hazard
Combustible.
Slight fire hazard when exposed to heat or flame.
Heating may cause expansion or decomposition leading to violent rupture of containers.
On combustion, may emit toxic fumes of carbon monoxide (CO).
May emit acrid smoke.
Mists containing combustible materials may be explosive.
Combustion products include:
carbon dioxide (CO2)
mineral oil
Chemwatch: 78-3330
Version No: 2.1.1.1
Page 2 of 8
Toro SAE 30 Engine Oil
Issue Date: 04/04/2017
Print Date: 05/10/2018
Continued...