Form No. 3408-727 Rev A Power Plex™14in 40V MAX String Trimmer Model No. 51482—Serial No. 317000001 and Up Model No. 51482T—Serial No. 317000001 and Up Register at www.Toro.com.
Safety If you have questions or problems, call toll free 1-800-237-2654 (US) or 1-800-248-3258 (Canada) before returning this product. WARNING: When using electric gardening appliances, always follow basic safety precautions to reduce the risk of fire, electric shock, and personal injury, including the following: WARNING Failure to follow all warnings and instructions may result in electric shock, fire and/or serious injury. WARNING Read all safety warnings and all instructions.
F. Keep your hands and feet away from the cutting area. operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in this manual. 3. Power tool use and care 4. Service A. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. B. C. D.
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal136-2465 136-2465 Model 51482 decal136-2466 136-2466 Model 51482T decal136-2473 136-2473 decal136-2471 136-2471 decal136-2474 136-2474 decal136-2476 136-2476 4 1. The battery pack is charging. 3. The battery pack is too warm. 2. The battery pack is fully charged. 4. Replace the battery pack.
decal136-2533 136-2533 1. Warning—read the Operator’s Manual; keep away from moving parts; keep all guards and covers in place; wear eye protection; do not operate in wet conditions. decal136-2534 136-2534 1. The battery does not come out of the box fully charged. 4. Stop—follow these instructions before first use. 2. Place the battery in the battery charger. 5. Read the Operator’s Manual. 3. Wait until the battery is fully charged before the first use.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 4 Description Use Qty. No parts required – Mount the battery charger (optional). Connector knob 1 Unfold the handle. Auxiliary handle 1 Install the auxiliary handle. Guard Phillips head screw 1 4 Install the guard. Note: The battery pack is not fully charged when you purchase it. Before using the tool for the first time, refer to Charging the Battery Pack (page 9).
2 Unfolding the Handle Parts needed for this procedure: 1 Connector knob Procedure 1. Remove the handle connector knob from the tool (A of Figure 2). 2. Unfold the handle (B of Figure 2). 3. Install the handle connector knob to secure the handle (C of Figure 2). Note: The nut that holds the handle connector knob in place is lightly secured in the connector housing.
3 4 Installing the Auxiliary Handle Installing the Guard Parts needed for this procedure: Parts needed for this procedure: 1 Auxiliary handle 1 Guard 4 Phillips head screw Procedure Procedure 1. Line up the groove along the handle with the groove on the auxiliary handle and slide the auxiliary handle toward the trimmer handle (A of Figure 3). Remove the 4 Phillips head screws that are taped to the guard and use them to install the guard (Figure 4). 2.
Removing the Battery Pack from the Trimmer Operation Starting the Trimmer Press the battery latch on the machine to release the battery pack and slide the battery pack out of the machine (Figure 8). 1. Make sure that the vents on the trimmer are clear of any dust and debris. g192774 Figure 8 g195377 Figure 5 1. Battery latch 1. Trimmer venting areas Charging the Battery Pack 2. Align the cavity in the battery pack with the tongue on the handle housing (Figure 6).
Left Light Right Light Indicates: Off Red Charger is on; no battery pack inserted Red Red Battery pack is charging Green Red Battery pack is charged Orange Red Battery pack is too warm Red Blinking Red Replace the battery pack Advancing the Line Using the Bump Feed g192748 1. Run the tool at full throttle. Figure 9 1. Battery pack cavity 2. Battery pack terminals 2. Tap the bump button on the ground to advance the line. The line advances each time the bump button is tapped.
Adjusting the Auxiliary Handle Operating Tips • Keep the trimmer tilted toward the area being cut; this is 1. Release the auxiliary-handle latch (A of Figure 12). the best cutting area. 2. Slide the auxiliary handle up or down to your desired height (B of Figure 12). • The string trimmer cuts when you move it from left to right. This prevents the trimmer from throwing debris at you. Important: Do not remove the rubber bumper. 3.
Maintenance Replacing the Spool After each use of the trimmer, complete the following: 1. Remove the battery from the trimmer. Use only 2 mm (0.08 inch) diameter monofilament string. Use the original manufacturer’s replacement string for best performance (Toro Part No. 88546). 2. Wipe the trimmer clean with a damp cloth. Do not hose the trimmer down or submerge it in water. Important: Using a larger diameter string causes the motor to overheat and fail. 1. Remove the battery. CAUTION 2.
Replacing the String Storage 1. Remove the battery. Important: Store the tool, battery pack, and battery charger only in temperatures between -20°C (-4°F) and 70°C (158°F). 2. Remove the spool; refer to Replacing the Spool (page 12). Important: Unplug the charger if you store it below -20°C (-4°F) or above 70°C (158°F). Important: If you are storing the tool for a prolonged period of time, remove the battery pack.
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem The tool does not start. Possible Cause Corrective Action 1. The battery is not fully installed in the tool. 1. Remove and then replace the battery into the tool, making sure that it is fully installed and latched. 2.
Notes:
The Toro Promise - Electric Products A Three-Year1 Full Warranty for Residential Use for the United States and Canada The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant this product for three years against defects in material or workmanship when used for normal residential purposes.* 1 Does not include the battery. 1 Year Battery Warranty for Residential Use.
