Operator's Manual

g024904
Figure25
1.Clutchbracket4.Spring
2.Barrel
5.Cable
3.Cablehousing
6.Locknuts
3.Graspthebarrelwith1handandliftthecable
housinglightly(Figure25).
Note:Liftingthecablehousingatthebarrel
shouldremovetheslackfromthecablebut
applynotensiontothespring.
4.Whileholdingtensiononthecable,useyour
otherhand,rotatethejamnutsuntilthenutsare
ushtotheclutchbracket(Figure25).
5.Tightenthejamnutstosecurethebarreltothe
bracket(Figure25).
6.Checkthetensionofthecontrolcable.Repeat
steps2through4untilthereistensiononthe
Dyna-Clutchcablebutnotensiononthespring.
Note:Ifthereistoomuchtensiononthecable
andspring,theDyna-Clutchwillnotrelease
completely.Ifthereisnotenoughtensiononthe
cable,thecablemaydisconnectfromthepulley
bracket.
7.Ifyouneedtomakeanercableadjustment,
performthefollowing:
A.Loosenthe2jamnutsslightly(Figure25).
B.Rotatethejamnutstoclockwisetoincrease
cabletensionorcounterclockwiseto
decreasetension(Figure25).
C.Tightenthejamnutstosecurethebarrelto
theclutchbracket(Figure25).
8.StartthemachineandsetDyna-Clutchtothe
RUNpositionforafewmoments,thenmovethe
Dyna-ClutchtotheSTOPposition.
Note:Ifthebladescontinuetorotatewhenthe
Dyna-ClutchisintheSTOPposition,thereistoo
muchtensionontheclutchcable.Shutoffthe
engineandrepeatstep7untilthebladesdo
notrotatewhentheengineisrunningandthe
Dyna-ClutchisintheSTOPposition.
AdjustingtheBeltGuide
1.PlacetheDyna-ClutchleverintheRUNposition.
2.Measuretheairgapbetweenthebeltandthe
beltguide(Figure26).
g024873
Figure26
1.6mm(1/4inch)
measures-airgap
3.Beltguide
2.Belt4.Hex-headbolt
Theairgapshouldbeapproximately6mm(1/4
inch).Ifanadjustmentneedstobedone,performthe
following:
1.Loosenthehex-angeheadboltthatsecures
thebeltguidetotheengineplate(Figure26).
2.Whilekeepingthetopofthebeltguideparallel
tothebelt,movethebeltguidetowardoraway
fromthebeltuntiltheairgapiscorrect(Figure
26).
3.Tightenthehex-angeheadboltthatsecures
thebeltguidetotheengineplate(Figure26).
21