Owner's Manual

Dial Position: MANUAL PROGRAMS
The MANUAL PROGRAMS mode allows the
immediate start of an entire program (A, B or C).
When using the MANUAL PROGRAMS feature, the DDCWP will
essentially override the normal start time and begin immediately. Using
MANUAL PROGRAMS does not affect the previously scheduled run times.
They will begin as programmed once the MANUAL PROGRAMS feature
has completed its cycle.
Press PROG to select the program you wish to operate.
The display will show all the stations programmed in the selected program
Press NEXT if you wish to select a different station as the 1st station.
Press +/ON to turn ON the sequence.
Press NEXT to skip from a station that is currently irrigating to the next
one in the sequence.
Press -/OFF to turn OFF the sequence (before it is completed).
The display will show the remaining RUN TIME of each operating station.
Press DIAL to advance to SYSTEM OFF.
Dial Position: OFF
3 main functions can be performed in this dial position.
ALL PROGRAMS OFF - Irrigation is suspended for all programs. It will
remain suspended as long as the DIAL stays in this
position.
Press NEXT to set next function OR Press DIAL to advance to AUTO-RUN
RAIN DELAY: Irrigation is delayed for the selected number of days, one to seven.
Press +/ON or -/OFF to select the number of days.
The display will show the umbrella, DLY=DELAY and the day the irrigation
will resume (Flashing).
Installation Instructions: DDCWP Controller
(continued)
After the station wires are connected, remove the battery compartment
waterproof cap and take out the two 9VDC connectors.
Attach two 9VDC alkaline batteries (not supplied) to the battery
connectors, insert them into the battery compartment, replace the
battery compartment cap and turn it clockwise to its locked position.
It is important to add or change batteries with the controller in a dry
condition. If moisture gets into the battery compartment, it can lead to
deterioration of the batteries.
Note: When the controller powers up, it sends an “Off” pulse to all the
solenoids so they are calibrated for proper operation. This is why
the solenoids should be connected prior to attaching the batteries.
If it is desired to program the controller prior to installation, attach
two 9VDC alkaline batteries, program the controller and remove
the batteries before field installation. Then follow the steps above.
- 4 -
DIGITAL DIAL
Advancement button
RESET button
WA
TERPROOF CAP
Attach 2 9VDC
alkaline batteries
black
common wire
orange
master
valve
wire
MASTER
VALVE
C O M M O N T O A L L V A L V E S
red
station
wires
yellow rain
sensor wire.
DO NOT CUT IF NOT
CONNECTING TO A
RAINSENSOR
™
- 9 -
OFF
All Prog.
Rain Delay
0-7 days
Prog. Er.
Prog. A
Press Press Press
Prog. Er.
Prog. B
Prog. Er.
Prog. C
ddcwp_manual_gb_revised.ai 10/23/06 Page 4