Replacement Part List

15
Ethanol. Gasoline containing up to 10% ethanol by volume
(commonly referred to as E10) is acceptable. E15, E20 and
E85 are not.
Starting the Product
See Figures 6 - 7.
Starting the product differs depending on whether the engine
is cold or warm. Refer to the label on the air lter cover.
To Start a Cold Engine:
Follow these steps to start a cold engine.
1. Lay the product on a at, bare surface.
2. Push the primer bulb approximately eight times.
3. Set the choke lever to FULL CHOKE.
4. Depress trigger lock-out and squeeze throttle trigger
fully (thru step 7) and pull starter handle sharply until
engine attempts to start (no more than 4x).
5. Set the choke lever to HALF CHOKE.
6. Pull starter handle until engine runs, no more than 6
pulls.
7. Set the choke lever to RUN.
Note: In cooler environments, additional pulls of the
starter handle may be required with the choke lever in
the FULL CHOKE position.
To Start a Warm Engine:
Follow these steps to start a warm engine.
1. Lay the product on a at, bare surface.
2. Push the primer bulb up to eight times.
3. Set the choke lever to RUN.
4. Depress trigger lock-out and squeeze throttle trigger
fully, pull the starter cord.
Note: If the product does not start, repeat the previous
steps.
Figure 7
Stopping the Product
See Figure 8.
Follow these steps to stop the product.
1. Release the trigger.
2. Press and hold on/stop switch to (STOP) position until
the engine stops. The switch will automatically return to
the (ON) position when released.
Operation
Set Choke to FULL
Set Choke to RUN
Throttle
Trigger
On/Stop
Switch
Figure 8
Figure 6
Lock-out
Switch
Starter
Grip and
Rope
Throttle
Trigger
Primer
Bulb
On/Stop
Switch