Multiprotocol Ethernet Interface User's Manual

27
ICC
parameter subgroups (if any) contained in that parameter group are displayed
in the Parameter Subgroup Selection List (refer to section 10.4.3), and the
corresponding parameters are displayed in the Parameter List (refer to section
10.4.4). The following parameter groups are available:
All:
All parameters are
available (configuration,
command and monitor
parameters).
Basic Parameters:
Only
the configuration
parameters most commonly
used for drive setup are
available.
Extended Parameters:
All
other configuration
parameters that are not
“basic parameters” are available.
Command Parameters:
Only drive command parameters are available. Note
that although all parameters associated with drive control are available in this
selection, only those parameters that are identified as being for the “internal
option board” can be used to actually control the drive via the option board: all
other drive command parameters can only be monitored via the option board.
Monitor Parameters:
Only drive monitor parameters are available.
10.4.3 Parameter Subgroup Selection List
Subgroups can be used
to further filter the
parameters of a group
that are to be displayed
in the Parameter List.
Refer to Figure 12.
If the group currently
selected in the
Parameter Group
Selection List (refer to
section 0) has subgroups
available, then choosing
the desired subgroup will further filter the parameters that are displayed in the
Parameter List. If the currently-selected group does not have any available
subgroups, then only the “All” subgroup will be shown, and all parameters in
that group will be shown in the Parameter List.
Figure 11: Parameter Group Selection List
Figure 12: Parameter Subgroup Selection List