Multiprotocol Ethernet Interface User's Manual

79
ICC
Figure 78: Selecting the Destination Element
d) “Communication” tab settings (refer to Figure 79):
i) Enter the Path to the interface card. A typical path is formatted as
Local_ENB,2,target_IP_address”, where:
Local_ENB is the name of the 1756-ENBx module in the local
chassis (we named ours “EIP” in section 13.2.3),
2 is the Ethernet port of the 1756-ENBx module in the local
chassis, and
target_IP_address is the IP address of the target node.
In our example, this path would be entered as
“EIP,2,192.168.16.128”.
Figure 79: Setting the Communication Path