Owner's manual

User’s Manual 7-6
HW Setup
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6, Extending
battery life.
Built-in LAN
This feature enables or disables the Built-in LAN.
Device Config
Device Configuration
This option allows you to set how the computer's hardware devices will be
configured.
USB
USB KB/Mouse Legacy Emulation
You can use this option to enable or disable USB keyboard/mouse legacy
emulation so that, even if your operating system does not support USB
devices, you can still use a standard USB mouse and keyboard - to achieve
this you should set the appropriate option(s) to Enabled.
■ The Wake-up on LAN function consumes power even when the
system is off. Leave the AC adaptor connected while using this
feature.
■ To enable it, you must check both the "Allow the device to wake the
computer" and "Only allow management stations to wake the
computer" check box within the "Intel Network Connection".
Enabled
Enables Wake-up on LAN (Default).
Disabled
Disables Wake-up on LAN.
Enabled
Enables Built-in LAN functions (Default).
Disabled
Disables Built-in LAN functions.
All Devices
The computer's BIOS will setup and configure all
devices.
Setup by OS
The operating system will setup and configure all
of the devices that it can control (default).
Enabled
Enables the USB Legacy Emulation function
(Default).
Disabled
Disables the USB Legacy Emulation function.