+01EN.
+01EN.BOOK Page 1 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller Thank you very much for purchasing TOSHIBA/Carrier Remote Controller for Air Conditioner. Please read this “Owner’s manual” carefully before using your Remote Controller for Air Conditioner. • Be sure to obtain the “Owner’s manual” and “Installation manual” from constructor (or dealer). Request to constructor or dealer • Please clearly explain the contents of the Owner's manual and hand over it.
+01EN.BOOK Page 2 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller 1 PRECAUTIONS FOR SAFETY WARNING WARNINGS ABOUT INSTALLATION • Make sure to ask the qualified installation professional in electric work to install the remote controller. If the remote controller is inappropriate installed by yourself, it may cause, electric shock, fire, and so on. • Make sure to install the air conditioner specified by TOSHIBA/Carrier and ask the exclusive dealer when installing.
+01EN.BOOK Page 3 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller CAUTION CAUTIONS ABOUT INSTALLATION • Do not install the remote controller in a place where its signals do not reach the indoor unit. • Do not install the remote controller in a place under the direct sunlight or close to any heat source. It may cause malfunction. The fluorescent lamp with rapid start system or inverter system may disturb the signal reception.
+01EN.BOOK Page 4 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller 2 PART NAMES AND FUNCTIONS Max. 8 indoor units can be operated by a remote controller. Push each button to select a desired operation. • The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing ON/OFF button only. Illustration of LCD shown below is for explanation. It may differ from the actual LCD.
+01EN.BOOK Page 5 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller 8 9 10 16 11 12 13 SETTING 14 15 8 9 Operation mode 14 Test run display 15 Displayed during a test run. 10 is displayed during the operation. If the remote controller setting is prohibited by the central remote controller, flashes when [ON/ OFF], [Mode] or [Setup temperature] button is pushed and change is not accepted. 12 Set temperature display The selected set temperature is displayed.
+01EN.BOOK Page 6 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller 3 HOW TO OPERATE INDOOR UNIT COOL/HEAT AUTO HEAT , DRY , COOL , FAN , (During FAN mode, the fan speed is not automatically changed.) 4 Power supply Turn on the power supply switch 12 hours before starting operations. After the power supply has been turned on, the operation of the remote controller is not accepted for approximately 1 minute. It is not a failure.
+01EN.BOOK Page 7 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller Automatic Cool/Heat When all indoor units in the identical refrigerant system are controlled as a group, the cooling or heating operation is automatically performed with the difference between the setup temperature and the room temperature. Dry operation • Dry function may not be provided depending on the using indoor unit, even if Dry ( ) is displayed on the LCD of the remote controller.
+01EN.BOOK Page 8 Thursday, October 8, 2009 3:37 PM Owner’s Manual Simple wired remote controller MEMO ....................................................................... ....................................................................... ....................................................................... ....................................................................... ....................................................................... ..............................................
+01EN.