Network Card User's Manual

 50 
6 F 3 B 0 3 5 6
TermSTS
TermSTS Status Meaning
00H Normal complete
01H Register designation error • Occurs if a register other than XW, YW,W, LW, RW, D, F, T, C, or SW is
designated as the data storage register in one of the following requests.
Requests: Remote station loopback, Register read/write.
• In a register read or write request, the request designated a read or write from
a T register to a register other than a T register.
(This also applies to C registers.)
02H Response timeout • Occurs if a response is not received within the designated time for a remote
station loopback or register read/write request.
03H Parameter error • Occurs if a value other than 2 is designated for the module ID.
• Occurs if a value other than 1 (T2N/T3H) or 2 (T3H) is designated for the
channel number.
04H Register write protect • Occurs if an attempt to write is made when the remote registers were write
protected.
• Occurs if an attempt to read is made when the local registers were write
protected.
05H (Reserved)
Module error • Occurs if the module is down.
• Occurs if the master station of PC link times out
06H
Initialization in progress • Occurs if the module is initializing.
07H No send channel (CH)
• Occurs if the corresponding S20LP-station is not installed.
08H Invalid station number • Occurs if the local station address designated 0 or over 64.
• Occurs if the remote station address was set up the same local station
address.
09H Transfer size error • Occurs if either 0 or 129 or more words were designated for either a register
read/write or a remote station loopback request.
0AH Boundary error • Occurs if the specified area (start address + register range) does not exist in
the T2N/T3H data storage registers.
Requests: Remote port loopback, Register read/write
0BH Transmission error • Occurs if the S20LP-station returns an error response.
Detailed information (the S20LP-station response status) is stored at B+1.
0CH I/O no answer error
• Occurs if the T2N/T3H cannot access S20LP-station.
IC card designation error
(T3H)
• Occurs if an error occurs when the T3H IC card is being used as register
(expanded F register) in one of the following request.
(See the T3H Instruction Manual.)
Request: Register read/write
1. Occurs if IC card is not setting up.
2. IC card type error
3. Register write protected
0DH
(Reserved : T2N)
0EH Retry timeout error
• Occurs if a T2N retransmission times out.
0FH (Reserved)