User Guide

3 Tests and Diagnostics 3.20 Only One Test
Satellite R10 Maintenance Manual (960-509) 3-45
Connect the USB test module and USB cable to the computer.
Input the test port number and press Enter.
OK message appears in the display if the test ends without an error.
NG message appears in the display if an error is found during the test. Confirm the
connection of cable, and then execute the test again.
Press 9 and Enter to return to Only One Test menu.
Subtest 05 LED
This subtest checks if each LED lights properly.
The following message appears in the display in order. Follow the instructions in the
display to execute the test.
[HDD Access LED test]
Confirm the LED of HDD status blinks properly.
Press any key and following message appears in the display.
[Caps/Num/Overlay BT/W-LAN LED test]
(1) Press [Caps Lock ] key ! ...Caps (on/off)
(2) Press [Fn + F10 ] key ! ...Arrow (on/off)
(3) Press [Fn + F11 ] key ! ...Num (on/off)
(4) Slide [BT/W-LAN switch L&R]! (on/off)
Confirm corresponding LED lights properly.
Press Enter and following message appears in the display.
Check [DC-IN]&[Power]&[Main Battery] LED=
Green/Orange
Check if the each LED lights in the same color shown in the display (Message
switches Green <-> Orange).
Press Enter to return to the Only One Test menu.