User Guide

4 Replacement Procedures 4.5 HDD
Satellite R10 Maintenance Manual (960-509) 4-15
5. Remove the following screws fixing the HDD holder.
? M3.0x4.0S FLAT BIND screw x4
6. Detach the HDD holder from the HDD.
Figure 4-6 Removing the HDD holder
Installing the HDD
The following describes the procedure for installing the HDD. (See Figure 4-5 and 4-6.)
CAUTION: HDD frame and laminate can not be reused. If you detach the laminate
package from HDD frame, be sure to use a new HDD frame and
laminate package when replacing.
1. Install the HDD holder to the HDD and secure it with the following screws.
? M3.0x4.0S FLAT BIND screw x4
2. Connect the HDD FPC to the connector CN1800 on the system board and the
connector of the HDD assembly.
3. Set the HDD assembly to the HDD slot from the opposite side of the connector.
4. Insert the HDD assembly into the HDD slot of computer.
5. Install the HDD slot cover and secure it with the screw (with e-ring).
M3.0x4.0S FLAT BIND
M3.0x4.0S
FLAT BIND
HDD holder
(HDD frame and laminate)
HDD