User Guide

4 Replacement Procedures 4.7 Keyboard
Satellite R10 Maintenance Manual (960-509) 4-19
4.7 Keyboard
Removing the keyboard
The following describes the procedure for removing the keyboard. (See Figure 4-9.)
1. Open the display.
2. Insert your nails in the slot of both sides of the keyboard holder and lift it up.
3. Remove the following screws securing the keyboard.
? M2.5x2.8B FLAT BIND screw x2
4. Lift the top edge of the keyboard and bring the edge to the front to lay on the
computer. Unlock the connector and disconnect the keyboard flexible cable from
the connector CN3200 on the system board.
5. Remove the keyboard.
Figure 4-9 Removing the keyboard
CN3200
Keyboard holder
M2.0x3.0B
FLAT BIND
M2.0x3
.0B FLAT BIND
Keyboard