User Guide

4 Replacement Procedures 4.8 Bottom cover assembly
Satellite R10 Maintenance Manual (960-509) 4-21
4.8 Bottom cover assembly
Removing the bottom cover assembly
The following describes the procedure for removing the bottom cover assembly. (See
Figure 4-10 and 4-11.)
1. Disconnect the touch pad cable from the connector CN3201 on the system board.
Figure 4-10 Removing the touch pad cable
2. Close the display and turn the computer upside down.
3. Remove the following screws securing the bottom cover assembly.
? M2.0x6.0B FLAT BIND screw x19 (Described as "6" in figure)
? M2.0x3.0B S-THIN FLAT BIND screw x2 (Described as "3" in figure)
4. Pull up to remove the bottom cover assembly from the computer.
CN3201
Touch pad cable