User Guide

4 Replacement Procedures 4.14 DC-IN jack

Satellite R10 Maintenance Manual (960-509) 4-35

4.14 DC-IN jack

Removing the DC-IN jack

The following describes the procedure for removing the DC-IN jack. (See Figure 4-23.)

1. Pull up the DC-IN jack straight from the slot of cover assembly.

2. Disconnect the DC-IN jack from the connector CN8800 on the system board

Figure 4-23 Removing the DC-IN jack

Installing the DC-IN jack

The following describes the procedure for installing the DC-IN jack. (See Figure 4-23.)

1. Connect the DC-IN jack to the connector CN8800 on the system board.

2. Install the DC-IN jack by fitting guide of slot of cover assembly.

IN jack

CN8800