User Guide

4.15 Penholder / RTC battery 4 Replacement Procedures
4-36 Satellite R10 Maintenance Manual (960-509)
4.15 Penholder / RTC battery
4.15.1 Penholder
Removing the penholder
The following describes the procedure for removing the penholder. (See Figure 4-24.)
1. Disconnect the RTC batter cable from the connector CN8760 on the system
board.
2. Remove the following screws securing the penholder and remove the penholder
from the cover assembly.
? M2.0x4.0B FLAT BIND screw x2
Figure 4-24 Removing the penholder
Installing the penholder
The following describes the procedure for installing the penholder. (See Figure 4-24.)
1. Install the penholder to the cover assembly and secure it with the following
screws.
? M2.0x4.0B FLAT BIND screw x2
Caution: When installing the penholder, be careful not to catch the wireless LAN
antenna cables and speaker cable arranged on the cover assembly.
2. Connect the speaker cable to the connector CN8760 on the system board.
M2.0x
4.0B FLAT BIND
Penholder
RTC battery cable
CN8760