User Guide

4.22 Microphone / Front panel 4 Replacement Procedures
4-48 Satellite R10 Maintenance Manual (960-509)
4.22 Microphone / Front panel
4.22.1 Microphone
Removing the microphone
The following describes the procedure for removing the speaker. (See Figure 4-33.)
1. Remove the following screws securing the both right and left mic holder.
? M2.0x4.0B FLAT BIND screw x2 (x1 for each side)
2. Pull up the mic holder straight and remove the mic holder from the cover
assembly.
3. Remove the microphone from the slot of cover assembly.
Figure 4-33 Removing the microphone
Removing the microphone
The following describes the procedure for removing the speaker. (See Figure 4-33.)
1. Fitting the microphone to the shapes of slot, install the microphone to the cover
assembly.
Install the mic holder to the cover assembly while fitting it to the slit of cover assembly
and secure them with the following screws.
? M2.0x4.0B FLAT BIND screw x2 (x1 for each side)
M2.0x4.0B FLAT BIND
Microphone
Mic holder (R)
Mic holder (L)