User Guide

4.25 LCD unit & FL inverter 4 Replacement Procedures

4-52 Satellite R10 Maintenance Manual (960-509)

4.25 LCD unit & FL inverter

Removing the LCD unit & FL inverter

The following describes the procedure for removing the LCD unit & FL inverter. (See

Figure 4-37 to 4-39.)

NOTE: When replacing the LCD unit, do not give the hinge portion a strong press. It

may cause the breakage of the hinge assembly.

Also, Use a stand or something under the LCD part to keep the LCD part

level while replacing it.

1. Peel off the mask seals (6 points) from the LCD mask.

2. Remove the following screws securing the LCD mask.

? M2.0x6.0B FLAT BIND screw x6

3. Laying down the LCD to make the LCD and the cover assembly flat, release the

latches and remove the LCD mask.

4. Remove the cross function button from the application switch board.

NOTE: When removing the LCD mask, be careful not to lose the cross function button

because the button is easily removed.

Figure 4-37 Removing the LCD mask

Cross function button

M2.0x6.0B FLAT BIND

LCD mask