User Guide

4 Replacement Procedures 4.25 LCD unit & FL inverter

Satellite R10 Maintenance Manual (960-509) 4-53

5. Turn up the insulator and disconnect the HV cable from the connector of FL

inverter.

6. Remove the following screws securing the LCD unit.

? M2.0x4.0B FLAT BIND screw x4

7. With the bottom edge of the LCD unit on the display cover, raise the top edge of

the LCD unit.

NOTE: When putting the LCD unit on the display cover, lay a mat or something under

the LCD unit to protect the computer and the LCD from a scratch or

breakage.

8. Peeling off the glass tapes (2 tapes), disconnect the LCD harness and digitizer

harness from the connectors on the back of LCD unit.

9. Remove the LCD unit from the display cover.

Figure 4-38 Removing the LCD unit

M2.0x4.0 FLAT BIND

Glass tape

HV cable

M2.0x4.0 FL

AT BIND

Insulator