User Guide

4.26 Application switch board 4 Replacement Procedures
4-56 Satellite R10 Maintenance Manual (960-509)
4.26 Application switch board
Removing the application switch board
The following describes the procedure for removing the application switch board. (See
Figure 4-40.)
1. Remove the following screws securing the application switch board and pull up
the application switch board.
? M2.0x4.0B FLAT BIND screw x1
2. Disconnect the switch harness from the connector CN9510 on the application
switch board.
Figure 4-40 Removing the application switch board
Installing the application switch board
The following describes the procedure for installing the application switch board. (See
Figure 4-40.)
1. Connect the switch harness to the connector CN9510 on the application switch
board.
2. Install the application switch board to the display cover and secure it with the
following screws.
? M2.0x4.0B FLAT BIND screw x1
M2.0x4.0B FLAT BIND
Switch harness
CN9510
Application switch board