User Guide

4.29 LCD/digitizer harness & Wireless LAN antenna cables 4 Replacement Procedures
4-64 Satellite R10 Maintenance Manual (960-509)
4.29 LCD/digitizer harness & Wireless LAN antenna cables
Removing the LCD/digitizer harness & wireless LAN antenna cables
The following describes the procedure for removing the LCD/digitizer harness & wireless
LAN antenna cables. (See Figure 4-43 and 4-44.)
1. Pull out the wireless LAN antenna cables from the guide.
2. Remove the following screws and LCD harness holder.
? M2.5x2.8B FLAT BIND screw x1
3. Remove the following screws and digitizer harness holder.
? Unique screw CPU stud screw x1
? M2.5x6.0S PSP TIGHT screw x1
4. Remove the following screws securing the hinge assembly.
? M2.5x6.0B FLAT BIND screw x1
? M2.5x6.0S PSP TIGHT screw x1
5. Remove the hinge rear cover from the hinge assembly.
6. Detach the cover assembly from the display cover.
Figure 4-43 Removing the cover assembly
LCD harness holder M2.5x2.8B FLAT BIND
M2.5x6.0B FLAT BIND
M2.5x6.0S PSP TIGHT
Digitizer harness holder
Hinge rear cover
CPU stud