User Guide

4.29 LCD/digitizer harness & Wireless LAN antenna cables 4 Replacement Procedures

4-66 Satellite R10 Maintenance Manual (960-509)

Installing the LCD/digitizer harness & wireless LAN antenna cables

The following describes the procedure for installing the LCD/digitizer harness & wireless

LAN antenna cables. (See Figure 4-43 and 4-45.)

1. Stick the wireless LAN antennas on the display cover and arrange their cables.

2. Stick the acetate tape (5 points) on the display cover.

Figure 4-45 Arranging the wireless LAN antenna cables

3. Pass the LCD harness through the hole of hinge assembly.

4. Pass the digitizer harness through the hole of hinge assembly.

5. Pass the wireless LAN antenna cables through the hole of hinge assembly.

6. Installing the hinge cap to the hinge assembly, secure the hinge assembly to the

display cover with the following screws .

? M2.5x6.0B FLAT BIND screw x2

Caution: Before installing the hinge cap, confirm the right arrangement of each

harnesses and cables.

7. Arranging the LCD harness on the display cover, secure the LCD harness ground

plate with the following screws .

? M2.5x6.0B FLAT BIND screw x2

8. Arranging the digitizer harness on the display cover, install the digitizer harness

hold plate.

9. Install the cover assembly and hinge rear cover to the display cover.

Wireless LAN antenna

Acetate tape