Operation Manual

19
Connections
AV
S
SELECT
P
I
VIDEO OUT AUDIO OUT
SUBWOOFER SURROUND FRONT
CENTER
COAXIAL OPTICAL
DIGITAL
L
R
5.1CH
SURROUND
2CH BITSTREAM
/ PCM
VIDEO
Y
P
B
PR
AC IN
SELECT
P
I
SELECT
P
I
Notes
• Refer to the owner’s manual of the connected equipment as
well.
• When you connect the DVD player to other equipment, be
sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD player near a tuner or radio, the radio
broadcast sound might be distorted. In this case, place the
DVD player away from the tuner and radio.
• The output sound of the DVD player has a wide dynamic
range. Be sure to adjust the receiver’s volume to a moderate
listening level. Otherwise, the speakers may be damaged by
a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the
DVD player’s power cord. If you leave the amplifier power on,
the speakers may be damaged.
Connecting to a TV (Using the component video jacks)
Signal flow
To PR video
input
To PB video
input
To Y video input
TV or monitor with component video
(PROGRESSIVE) inputs
or
TV or monitor with component video
(INTERLACED) inputs
PROGRESSIVE (525P (480P)) outputs/inputs
Some TVs or monitors are equipped with component
video inputs that are capable of reproducing a
progressively scanned video signal. Connecting to
these inputs allows you to view the high quality pictures
with less flicker.
Notes
• To output video signals in the progressive format, set
“PAL/Auto” to “Auto”
60
.
• A VIDEO CD recorded in the PAL system cannot be
viewed in the progressive output format. Video signals of
those discs are output always in the interlaced output
format.
INTERLACED outputs/inputs
Some TVs or monitors are equipped with component
video inputs. Connecting to these inputs allows you to
enjoy higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y,
C
B, CR)
In some TVs or monitors, the color levels of the
playback picture may be reduced slightly or the tint may
change. In such a case, adjust the TV or monitor for
optimum performance.
To Y
VIDEO
OUT
To PR
VIDEO
OUT
To PB
VIDEO
OUT
To 2CH AUDIO OUT
(R: red, L: white)
To wall outlet
To audio input
Audio cable
• Make the following setting.
TV
TV or monitor
with component
video inputs
See “Customizing the Function Settings”
beginning from
56
.
Setting
“Video Out Select”
60
“Audio Out Select”
61
“Bitstream” or “PCM”
“Video”
or
“S Video”
Power cord
Switching the output signal (interlaced/
progressive) using the remote control
(only when the SELECT (I/P) switch is set to “P”)
You can temporarily switch the output signal for better
picture quality.
Press Y/PB/PR SELECTOR on the remote control.
Set to “P”.
Set to “I”.
* After setting this switch (I/P), be sure to
power off the DVD player then turn it on
to activate the setting.