Use and Care Manual

ASSEMB

LY INSTRUCTIONS

1. Place your pump inside the filter box, close to the center.

Make sure that the outlet points up. Route the cord through

the hole in the top corner of the filter box bottom. Fig. 1

NOTE: Pump is NOT INCLUDED. This filter is compatible

with pump models MD11300, MD11500, DD11210

DD11330 and DD11560.

Fig. 1

2. Place the bio-balls around the pump. Fig. 2

Fig. 2

3. Connect the extension tube to the outlet of the pump using

the adapter (adapter is part of fountain head kit). Fig. 3

NOTE: Fountain head kit (item #N6100) is NOT INCLUDED,

and is not required for operation.

Fig. 3

4. Place one of the fine filter pads over the bio-balls and pump.

Then place one of the coarse filter pads over the fine filter

pad. Fig. 4

NOTE: The fine filter pad is blue and the coarse filter pad is

black.

Fig. 4

Extension tube

Adapter

Pump

Filter box

bottom

Bio balls

Pump

Coarse filter pad

Fine filter pad

Filter box bottom