Installation Guide

13
Before using it for the first time
Introduction
Procedure for first-time use
Turn on the circuit breaker.
Remove the Supplementary Protector cover.
Turn on the power lever on the Supplementary Protector.
Replace the Supplementary Protector cover.
Turn on the hot and cold water valves connected to the function module.
ӿ When there is no hot and cold water from the shower for cleaning the tub, open the inspec-
tion port (installed on site) that is located near the shower and check the water shut off valve.
ӿ The position of the shut off valves will vary depending upon site.
Please turn the shut off valves on and supply hot and cold water to the function module.
To circuit breaker
Function module
Water heater
(Not included with product)
Hot water
Hot water
Hot water valve
Cold water Cold water
valve
Supply temperature 140-158°F (60-70°C)
Water pressure 29-108.75 psi (0.2-0.75MPa)
flowing
Cold water pressure
29-108.75 psi (0.2-0.75MPa) flowing
Power lever
Supplementary
Protector cover
ON
OFF