Installation Guide

17
Filling the tub with hot water
ӿ If the controller is not used, the system returns to auto after around one minute.
The tub is filled with water at a preset temperature. The process stops automatically when the preset
water level is reached.
Close the drain plug and turn the On/Off button to on.
Press the to on.
After around 10 seconds (but at most 20 seconds) warm water will begin
to flow from the outlet.
Setting the tub water temperature and level.
Press .
Water
level
Water Level Temperature (Guide)
 When the tub has filled, a melody will be played and then stop.
 When you want to stop filling a tub, turn the
to off. (The water flow will stop after about 10 seconds.)
 When the controller screen is not the display shown, please press the
 The temperature of the water coming from the outlet that fills the tub and the temperature settings will not
necessarily match due to such factors as ambient temperature and water pipe length. Please use these as a
guide.
 The water level is a guide for filling the tub when empty. If there is water still in the tub, the water level will vary.
►See page 23.
When running very hot water into the bath, beware of scalding.
● The set temperature and water level are retained in memory.
Setting
3
2
1
Capacity Level
Approx. 144 gal (545 L)
Approx. 133 gal (505 L)
Approx. 123 gal (465 L)
17” (43 cm)
Initial Setting 16” (40 cm)
15” (37 cm)
113°F (45°C)
106°F (41°C)
Initial Setting 104°F (40°C)
102°F (39°C)
95°F (35°C)
Low (cold)
Operation