Installation Guide

21
This adds cold water to lower the temperature of the bath water.
Lowering the bath temperature (Cooling water)
ӿ When the horizontal gauge (about 26 gallons or about 100 L) on the screen reaches the end, it will
stop automatically.
Switch screens.
Turn the Lower button to on.
After about 10 seconds (but at most 20 seconds), cold water will flow
from the Fill-Tub outlet.
Press .
 This won’t work if the Lower button or the Higher button is on.
When the bath water has reached the desired temperature, turn off the
Lower button.
The water flow will stop after about 10 seconds.
 Please operate with the On/Off button set to on.
 This won’t work unless there is water in the tub. Put water in the tub. ► See page 17.
ӿ Turn this button off or check to see that it is
Operation